Quick3D Polymaker PolyMax-PETG
PolyMax · PETG filament for FFF
Overview
Modified PETG/PCTG blend filament with markedly higher fracture toughness and impact resistance than PolyLite PETG, keeping PETG chemical resistance for durable prototypes and end-use parts.
Summarised from the Polymaker product page.
- Material type
- Engineering
- Brand family
- PolyMax
- Polymer
- PETG
- Processing technology
- FFF
- Material form
- Filament
- Manufacturer
- Polymaker
- Reinforcements
- None
Characteristics
- Chemical resistantRated "Good" against at least four of the five chemical groups tested, or described as chemical resistant on the datasheet.
Certifications
- REACHComplies with the EU REACH regulation on chemicals — no substances of very high concern above the allowed limits.
- RoHSFree of restricted hazardous substances such as lead, mercury and cadmium (EU RoHS directive) — needed for electrical and electronic products sold in the EU.
As stated by Polymaker — RoHS and REACH are Polymaker declarations covering its whole product range. Ask us for the certificate if you need it for an audit.
Applications
Based on this material's datasheet values. Every part is different — ask an engineer to confirm it suits yours.
Physical
- 1.24g/cm³ ISO1183, GB/T 1033
- 9g/10 min 210°C, 2.16 kg
Thermal
- 79°C DSC, 10°C/min
- 373°C TGA, 20°C/min
- 82°C ISO 306, GB/T 1633
- 72°C ISO 75 1.8MPa
Mechanical
- 1684 ± 135MPa ISO 527, GB/T 1040
- 37.9 ± 1.4MPa ISO 527, GB/T 1040
- 5.22 ± 1.5% ISO 527, GB/T 1040
- 1068 ± 94MPa ISO 178, GB/T 9341
- 58.3 ± 0.38MPa ISO 178, GB/T 9341
- 11.6 ± 0.8kJ/m² ISO 179, GB/T 1043
Chemical resistance
Versus other PETG
See where it ranks against the 11 other PETG materials we stock.
Typical values from each manufacturer's datasheet. Test methods can differ between brands, so treat small gaps as a tie.
Downloads
- Manufacturer datasheetSent on requestRequest
- Quick3D summaryThis page as a printable PDF
Values from the Polymaker technical data sheet and product page. Last updated . Typical values, not guaranteed minimums — see the disclaimer below.