Quick3D Polymaker Polywood-PLA
PolyWood · PLA filament for FFF
Overview
Wood-look PLA produced by foaming technology rather than added wood powder, giving wood-like density and appearance (0.8 g/cm³) without the clogging risk of wood-filled filaments.
Summarised from the Polymaker product page.
- Material type
- Specialty
- Brand family
- PolyWood
- Polymer
- PLA
- Processing technology
- FFF
- Material form
- Filament
- Manufacturer
- Polymaker
- Reinforcements
- None
Characteristics
- BiobasedMade mainly from renewable plant sources. Shown for PLA-based materials — PLA is produced from plant sugars such as corn or sugarcane.
Certifications
- REACHComplies with the EU REACH regulation on chemicals — no substances of very high concern above the allowed limits.
- RoHSFree of restricted hazardous substances such as lead, mercury and cadmium (EU RoHS directive) — needed for electrical and electronic products sold in the EU.
As stated by Polymaker — RoHS and REACH are Polymaker declarations covering its whole product range. Ask us for the certificate if you need it for an audit.
Physical
- 0.9g/cm³ ISO1183, GB/T1033
Thermal
- 59°C DSC, 10°C/min
- 151°C DSC, 10°C/min
- 60°C ISO 306, GB/T 1633
- 50°C ISO 75 1.8MPa
Mechanical
- 1688.5 ± 80.8MPa ISO 527, GB/T 1040
- 24.4 ± 0.3MPa ISO 527, GB/T 1040
- 8.8 ± 0.3% ISO 527, GB/T 1040
- 1958.9 ± 72.6MPa ISO 178, GB/T 9341
- 50.2 ± 1.6MPa ISO 178, GB/T 9341
- 2.4 ± 0.3kJ/m² ISO 179, GB/T 1043
Chemical resistance
Versus other PLA
See where it ranks against the 16 other PLA materials we stock.
Typical values from each manufacturer's datasheet. Test methods can differ between brands, so treat small gaps as a tie.
Downloads
- Manufacturer datasheetSent on requestRequest
- Quick3D summaryThis page as a printable PDF
Values from the Polymaker technical data sheet and product page. Last updated . Typical values, not guaranteed minimums — see the disclaimer below.